How to reset the system parameters of a CNC lathe?

The steps to reset the system parameters of the CNC lathe

1.enter parameter modification mode ‌

Switch the machine tool to MDI (Manual Data Entry) mode and ensure that the parameter write permission is enabled (for Fanuc systems, the parameter writability should be set to 1) ‌

For the Guangshu system, you need to press the "Parameters" key first, and then unlock the parameter modification permission through the "Settings" key ‌

 2.modify the key parameter ‌

axis parameters ‌ : For example, 1020 (axis name), 1022 (coordinate system axis number), and 1023 (servo axis number) need to be set to ‌ according to the type of machine tool

 limit parameters ‌ : 1320 (positive limit), 1321 (negative limit) need to be adjusted according to the actual stroke ‌

Backlash compensation ‌ : if the X-axis backlash compensation parameter (No. 34) and compensation amount (No. 35) need to be input according to the actual measured values ‌

3.save and restart ‌

After entering the value, press the "Input" key to confirm and restart the machine tool to make the parameter take effect ‌

Fanuc systems needs to set 1815#5 to 1 and then power off and restart ‌

‌

4. Verification and debugging ‌

Manually move each axis to check for overtravel or alarm, and fine-tune the parameters ‌ if necessary

 Note ‌ : Be sure to back up the parameters before modification to avoid malfunctions caused by misoperation