English Author: Site Editor Publish Time: 2026-01-07 Origin: Site
Misalignment when changing tools in a turret is indeed a headache. We can start from these key points to prevent it:
1. Tool parameter error prevention
Program verification : Automatically compare tool parameters using numerical control system variables (such as $TC_DP6[T,D]), and stop the machine and alarm if they do not match.
Operating specification : Check the tool number and parameters before changing the tool to avoid manual input errors.
Ⅱ. Tool Magazine Maintenance
Daily cleaning : blow the tool magazine with compressed air every day and wipe the tool sleeve with anti-rust oil.
Deep maintenance : Thoroughly clean the tool magazine weekly and calibrate it back to the zero position (error ≤0.01mm).
Ⅲ. Mechanical Structure Inspection
Regular inspection : confirm that the tool magazine returns to zero position and the spindle tool change point are in place.
Cleaning and maintenance : Keep the handle and sleeve of the knife clean to avoid getting stuck.
Iv. Optimization of Operation Processes
Idle run test : start up and idle the tool magazine and manipulator first, and check the limit switch.
Tool installation confirmation : when manually installing the tool, make sure it is in place and locked.
V. System Settings
Parameter calibration : Regularly calibrate the tool magazine back to zero position.
Cleaning device : The filter cotton of the self-cleaning tool magazine needs to be replaced regularly.
